Section 2 -Installation Requirements; Inspection; Moving The Unit - York YVAG012 Operation & Maintenance Manual

SECTION 2 –INSTALLATION REQUIREMENTS

INSPECTION

Remove any transit packing and inspect the unit to
ensure that all components have been delivered and that
no damage has occurred during transit. If any damage
is evident, it should be noted on the carrier's freight bill
and a claim entered in accordance with the instructions
given on the advice note.
Major damage must be reported immediately to your
local Johnson Controls representative.

MOVING THE UNIT

Prior to moving the unit, ensure that the installation site
is suitable for installing the unit and is easily capable of
supporting the weight of the unit and all associated
services.
The unit should be lifted using lifting lugs and a
spreader bar or frame of sufficient width to prevent
damage to the unit from the lifting chains.
The units shall be suitable for elevator or forklift truck
or crane for convenience of lifting. When transporting
JOHNSON CONTROLS
Cooke Industries - Phone: +64 9 579 2185
with a crane, a canvas hammock shall be used to come
round the unit base and be fastened. If the packaging
box has been removed, in order to move the machine,
please apply suitable partition to protect the surface and
the side panel, as shown in the picture below. During
the transit, the machine shall be kept in level condition
to avoid damaging the unit due to crude operation.
Email: sales@cookeindustries.co.nz
FORM NO.: 6U5M-A11M-NB-EN
Be particularly careful to ensure unit
steady. Pay special attention to the
weight distribution of the unit to avoid
maldistribution and the center of
gravity leans to the side of compressor.
Please try once before hoisting and
observe whether it is tightened and
whether there is any risk of tip-over of
the unit. The hoisting shall be slowly
lifted with constant speed to avoid the
tip-over of the unit and attention shall
be paid to the security of personnel
nearby.
Web: www.cookeindustries.co.nz
9