Checking Wiring And Connectors; Checking Propeller - Yamaha F225C Owner's Manual

10. Recheck the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Consult your Yamaha
dealer if the oil level is out of specified lev-
el.
1. Oil dipstick
2. Lower level mark
3. Upper level mark
11. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there are
oil leaks, stop the engine and find the
cause. Continued operation with a
problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01622]
12. Dispose of used oil according to local
regulations.
TIP:
For more information on the disposal of
G
used oil, consult your Yamaha dealer.
Change the oil more often when operating
G
the engine under adverse conditions such
as extended trolling.
EMU29113

Checking wiring and connectors

Check that each connector is engaged se-
G
curely.
Check that each ground lead is properly se-
G
cured.
EMU29174

Checking propeller

EWM01881
WARNING
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, place the
shift control in neutral, turn the main
switch to " " (off) and remove the key,
and remove the clip from the engine shut-
off switch. Turn off the battery cut-off
switch if your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
Maintenance
69