Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for TimberIN JSD-12L
- Page 1 GENERAL MANUAL OF GAS WATER HEATER...
- Page 2 OWNER’S MANUAL AUTOMATIC INSTANT GAS WATER HEATER IMPORTANT INFORMATION • Read all instructions before using the heater • As gas, propane (LPG) with 30 mbar pressure reducer and 2 kg / h of gas flow is used • Place the supplied rubber seal between the brass connector and gas inlet on the stove •...
-
Page 3: Table Of Contents
ONTENTS EATURES ..........................NSTALLATION EGULATIONS........................... NSTALLATION..........................OADING THE ATTERY .......................... NSTALLATION OF AS PIPE ......................NSTALLATION OF OTAND ATER IPE ..................NSTRUCTIONS ........................HE GASPIPE MAY BECOME CRACKED AND LEAK GAS DUE TOLONG TIME USE NSPECT ITREGULARLY ......N CASE OFGAS LEAKAGE NEVER MAKE A FIRE ORTOUCH ANY ELECTRIC SWITCHES NOT MAKE TELEPHONE CALL INTHE ROOM... - Page 4 EATURES Water controlled, fully automatic and easyto operate. Open the water valve, start pump to start ignition. The hot water will come out immediately. Close the water valve, stop pump. The hot water stops and the flamegoes out immediately. Ability to start at very low water pressure, applicable for many places. If the flame goes out unexpectedly during use, the gas supply will shut off automatically to protect against gas leakage.
-
Page 5: Installation Regulations
NSTALLATION EGULATIONS 1. It is forbidden to install this water heater in a closed room. Itmustbeinstalledinawell‐ventilatedarealargerthan 7.5㎡. Because the water heaterrequiresalarger quantity of oxygen when working, the area should have a minimum air‐induction opening of 0.06㎡(20x30 cm). 13 15 14 2. -
Page 6: Installation
NSTALLATION PERMANENT WALL MOUNT Hanging and installing the water heater (for reference only) Mark the holes on the wall, the position is subject to the actual model of your water heater, drill 4 holes of 8mm, put in the plastic dowels if needed. Hang the water heater, tighten the screws. -
Page 7: Installation Of Hotand Cold Water Pipe
NSTALLATION OF OT AND ATER Use hoses that can withstand pressure to connect incoming and outgoing water connection. Note that the °C outgoing pipe also must withstand temperatures up to 70 NSTRUCTIONS EFORE TART GNITION Please check to make sure that the gas type is in accordance with the one stipulated on the name plate (see page 2). -
Page 8: The Gaspipe May Become Cracked And Leak Gas Due Tolong Time Use .Inspect Itregularly
HE GAS PIPE MAY BECOME CRACKED AND LEAK GAS DUE TO LONG TIME USE NSPECT IT REGULARLY (Fig. 6) Check the connections of the gas pipe regularlywithsoapy water (Fig. 6) to make surethere is no gas leakage. Incase of gas leakage, never make fire or touch any electric‐switches for the ventilation fan, etc. Do not connect or disconnect any power plugs;... -
Page 9: Prevent Fire
REVENT It is absolutely forbidden to leave the burning water heater unattended. The water heater must be stopped before going to bed or going out. It is forbidden to put combustible or explosive objects close to the water heater. Never put a towel or clothes on the exhaust vent. -
Page 10: Replace The Batteries
• In very cold areas (with temperatures below 0ª ), please REVENT THE HEATER FROM FREEZING remove the draining stopper after use to release access water. It’s also recommended to disconnect the heater and move it to a storage place without risk for freezing. •... -
Page 11: Trouble & Troubleshooting
& T ROUBLE ROUBLESHOOTING Troubles Causes Troubleshooting The master gas Open the master gas valve or replace valve remains • • closed,or gas the gas bottle used up Malfunction of Open the master gas • • • • • pressure valve or replace adjuster the gas bottle... - Page 12 GAS HEATER PRO24 – FOR HEATING OF WATER IN HOT TUBS Thank you for choosing a gas heater from SpaDealers. The heater is easy to use. When connecting to a hot tub, there's a connection kit (A) with pump incl. hoses accessories (included in complete hot tub packages). It is connected as shown below.
- Page 13 Use your gas heater properly and you will avoid unnecessary problems not covered by the warranty. Here follows the most common problems that can be effectively avoided with proper maintenance. The most common problem that can occur is when contaminated water is used and the filter before the pump clogs up.
- Page 14 To reduce the minimum safe distance, a refractory material can used. On our website; www.spadealersuk.com, drawings can also be downloaded. The protective shelf is also available to order as an accessory. If the stove is left outside in freezing temperatures, then the heat exchanger could freeze and be destroyed. If the stove is not protected so that water cannot freeze in the heater, it shall be disconnected and taken indoors where the risk of freezing exists.
- Page 15 USE THE RIGHT LOW-PRESSURE REDUCER The types of gas cylinders and connection methods of low-pressure reducers (30mbar, 2kg / h) can vary. It is important that the correct low-pressure regulator is used. Here are examples of the correct type and also incorrect types. NEVER USE an adjustable controller.