Supported Kyocera Printer Models; Ecolan 2000E Hardware Installation - Kyocera FS-600 Network Manual

Supported Kyocera Printer Models

The EcoLAN 2000E is compatible with the FS/LS-600, 800, 1700+, 3700+, and any other
Kyocera printer with the new slide-in interface. The 2000E is compatible with the upper
(hard disk) interface slot of an FS/LS-7000 with a Software version of 25.05 or later. The
Software version is displayed on the printer status page.
The EcoLAN 2000E is NOT compatible with previous FS/LS-Series models, including,
FS/LS-400, 850, 1500/A, 1550/A/+, 1600/A/+, 1700, 3400/A/+, 3500/A, 3600/A/+, 3700,
5500, 6500/+.

EcoLAN 2000E Hardware Installation

The 2000E is a new slide-in interface board which does not require the removal of the
printer's main board for installation. These instructions describe the installation into the
FS-600 but would be similarly applicable to any Kyocera printer with the slide-in interface.
1. Remove the two screws securing the interface slot cover on the rear panel of the
printer and discard the interface slot cover.
2. Align the edges of the 2000E board with the rails in the interface slot and slide the
2000E into the printer. Secure with the two screws removed in Step 1.