Table of Contents
Advertisement
TRANSPORT AND STORING
Make sure there are no people, children and foreign objects around the area before transport-
ing the machine. Always take an extra caution during the transport. Ensure that the product
is well secured and that transport brackets are mounted. Always place the load as low as pos-
sible. Respect the danger zone even during transport. When lifting the equipment, never go
underneath suspended loads. Trailer used for transport should have working brakes.
Always store the machine in a dry place preferably underneath a cover when not in use. Ensure
that the product is stable and not likely to tip over. Never let children play where the machine
is being stored. Always keep in mind the risk of tipping!
MAINTENANCE AND SERVICE
Ensure that the unit is stable and cannot tip over during maintenance and service. Replace
damaged or worn parts immediately to reduce the risk of abrasion. Always perform mainte-
nance, service and inspection, as recommended. Use only original replacement parts or spare
parts with equivalent performance to reduce the risk of damage.All repairs and connections
with electricity must be performed by a qualified person.
SERVICE
•
Regularly check the condition of the gritter before the failure is a fact.
•
If cracks, twisting, bending, gaps or fatigue is discovered stop the operation and rectify
the fault.
•
Replace worn parts.
•
Disconnect the equipment from the tractor when remending the faults.
•
Rinse the equipment with water, if necessary, preferably after each use.
•
Lubricate moving parts regularly. For spare parts: Contact Kellfri Service
TROUBLESHOOTING
Error
There's no sand / salt coming out of the gritter
Spreading auger does not rotate
Poor spreading results
RECYCLING
Disposal of the product, disassemble and transport to the municipality's recycling station.
Contact your local authority for further information
Measure
Make sure that nothing is stuck in the spreading auger.
Caution Risk of crushing! The rotating auger must not be touched!
Unclog it from any object that is stuck in it.
Make sure the hydraulic hoses are properly connected.
Check the pressure in the system.
Check the rubber flap. Adjust if necessary
Check the setting of the spreader
7
Advertisement
Table of Contents
