Midi Faders Pages - Kurzweil K2600 Interface Manual

>> shows Mixdown||||<>Prog:|36|DuckWalk||||||||||
|||WXWXWXWX|WXWXWXWX|WXWXWXWX|WXWXWXWX||
whether sliders
control pan or |||wxwxC{wx|wxwxwxwx|wxwxwxwx|wxwxwxwx||
volume >>||z|z}~|z||z|z|z|z||z|z|z|z||z|z|z|z||
||||_|_|_|_||_|_|_|_||_|_|_|_||_|_|_|_||
||||||||||||||||||||||||||||||||||||||||
|||*****************||||||||||||||||||||
|Pan|||Volume|Ch|1-8|Ch9-16|||||||||Done
Shows which channels are
affected by sliders.
On the Mixdown page, pan and volume messages are sent to the internal K2600 sounds, to MIDI
Out, or both. All Mixdown-page channels have the same destination (local, MIDI, or both),
which is determined by the Control parameter on the MIDI-mode TRANSMIT page. You can
assign the sliders to control either volume or pan. The soft buttons at the bottom of the
Mixdown page let you select pan or volume control, on channels 1-8 or 9-16, allowing you to
temporarily use the 8 sliders (or the navigation and data entry buttons on the K2600R) as pan or
volume faders. Keep in mind that MIDI volume is a channel-speciÞc message. Therefore, if you
have more than one zone in a setup assigned to the same channel, moving any one of the
associated sliders will affect all those zones.

MIDI Faders Pages

The button just below Mixdown is called MIDI Faders (on rack models, press the Clear button
one or more times to view this page. The MIDI Faders page allows you to create a preset
conÞguration of any Controller assignment for each slider, along with an initial preset value for
that Controller. For each slider, you assign the MIDI channel, MIDI Controller number, and a
value. You can enter the value using any normal data entry method, or by moving the
corresponding slider on keyboard models. You can also assign several sliders to the same
channel, but assign each one to a different Controller number.
There are four different conÞgurations (pages 1Ð4), which you select with the soft buttons. Each
conÞguration remembers the last value you set for each slider. If you want to send those values
without moving the slider, press the Send button.
User Interface Basics
Mixdown and MIDI Faders Pages
Soft buttons for indicating
which channels are
affected by sliders.
3-11