ZV-600C Center Vise User's Manual
This is a center vise for the EGX-600/400. It can be used to secure in place rectangular plate material and round workpieces such
as medallions. To be made usable, it must be installed on the T-slot table of the EGX-600/400.
Names
Clamp plates
Pin
Installation
< EGX-600 >
< EGX-400 >
Clamp-plate
retaining screw
Scale label
Clamp plate
1.
Remove the guide at the front of the T-slot table.
2.
Pass the clamp bolts included with the EGX-600/400
through the T slots.
The vise can be installed on either the left or the right of the T-slot table.
3.
Place the vise on the T-slot table as you pass the bolts
through, then use the nuts included with the EGX-600/400
to tighten provisionally.
Nut
Bolt
T slot
Vise
Guide
Table
Examples of Clamp-plate Use
You can reorient or detach the clamp plate to match the workpiece being clamped.
* Clamp plate reoriented
4.
After you have positioned the vise, tighten the nuts
completely.
Nut
To position the vise, attach the guide and butt the vise flush against
the guide. This makes it easy to position.
Scale label
Affix this to the clamp as required to
serve as a guide for positioning
workpieces.
* Clamp plate removed
Copyright © 2002 Roland DG Corporation