Related Manuals for PATROLLINE HPS 845 E (H)
Summary of Contents for PATROLLINE HPS 845 E (H)
- Page 1 8 4 5 E ( H ) U S E R M A N U A L C A N - B U S C a r a l a r m a n d a n t i h i - j a c k s y s t e m 2020...
- Page 2 Blinker flashing based on opening features of the vehicle After the alarm was armed with the default (OEM) remote control or with the PATROLLINE remote control, the alarm will arm in the next 10 seconds, what signaled by the fixed light of the LED. During this time, if each sensor will be tested, the alarm will sign it with blinker flashing (number of the blinker flashing shows cause of the triggering, as table shows it in “Alarm memory”...
- Page 3 Nr. 1 (opening) button of the PATROLLINE remote control! After the inhibition time, if Nr. 2 (panic) button of the PATROLLINE remote control or closing button of the default remote control was pushed, the alarm will trigger till 30 seconds (beep/acoustic signal).
- Page 4 Difference between the two zones is that sensors memorized in zone 2. (similar to the ultrasonic) can be disarmed temporarily with twice pushing of closing button of the remote controls. With help of the default remote control and the PATROLLINE remote control too it is possible to be excluded the horn or siren function.
- Page 5 If the armed alarm is disconnected from its connector, after the reconnection it will stay in armed status, protected the car further. The alarm can immobilize the engine while the engine is ON when somebody hijack the car. This function is disarmed defaulty. Arming of this function can happen based on request of the client in writing.
-
Page 6: Safety Function
ULTRASONIC SENSOR ADDITIONAL INPUT ( BLUE WIRE ADDITIONAL SENSOR ( BLUE RED WIRE INPUT RADIO OPENING SENSOR, OR MOVING SENSOR HPS 845 R BONNET OPENING ( WITH ANALOG SIGNAL GAS SENSOR RADIO FREQUENCY DISTURBING HPS 845 R Safety function Door protection Senses door, trunk and bonnet opening Engine block Prevents starting of the engine of the car... - Page 7 2. or 3. emergency switching OFF operating mode instead of the default setting of the PIN code emergency switching OFF function! Only importer of PATROLLINE and his contracted partners can do the programming of the alarm, because special software and hardware is necessary to it! 1.
- Page 8 they can’t be used for PIN code emergency switching OFF not in every cars!) During push/draw of the brake pedal/hand brake the LED is ON, after the first digit you have to wait to switch OFF the LED. After that immediately push/draw the brake pedal/hand brake as many time as the second digit. After the LED switching OFF push/draw the brake pedal/hand brake as many time as the third digit.
- Page 9 If PIN code function of the alarm was programmed for brake pedal/hand brake mode, you have to do the above procedure on same way, only you have to push/draw the brake pedal/hand brake instead of turn ON/OFF the ignition key! WARNING! If the Antitheft / Antiagression function are programmed, before starting of the procedure, push the secret button used to the Antitheft / Antiagression, and keep it pushed until the procedure wasn’t finished!
- Page 10 To remind activated status of the valet function, the LED will flash continuously twice if you turn ON the ignition key. 2. Valet function usage with ignition key (this function operates too, if the PIN code emergency switching OFF function is programmed for the 3. operating opportunity, for the PIN code emergency switching OFF on ignition ON, automatically operation): Activation of the Valet function: Deactivation of the Valet function:...
- Page 11 Use litium battery (CR 2032 in case of the optional PATROLLINE remote control). Suggested the battery changing in every 2. years. Vehicle cleaning: should you clean the vehicle via high-pressure beams (hydro beam or similar), please protect the siren prior to commence cleaning.
- Page 12 It is required to write the following homologation number on the installation certificate to complete the conformity with the directive. E24 116R A-000031 Note: Patrolline Kft 8000 Székesfehérvár, Királysor 30. Tel/Fax: +36/22-317-367, +36/22-503-078 E-mail: info@riasztocentrum.hu Web: www.canbusriaszto.hu,...