Maintenance - Ryobi PCL704K Operator's Manual

STARTING/STOPPING THE VACUUM
See Figure 2, page 6.
 To start the vacuum: Depress the ON/OFF switch to
turn the vacuum on.
 To stop the vacuum: Depress the ON/OFF switch to turn
the vacuum off.
INSTALLING ACCESSORIES
See Figure 3, page 6.
Install only accessories designed for use with this vacuum
and/or the adaptor.
 Remove the battery pack.
 Insert the accessory into the opening in the dust bowl.
NOTE: For 1-7/16 in. accessories, insert the adaptor into
the opening and slide the accessory onto the adaptor.
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
NOTE: ILLUSTRATIONS START ON PAGE 6 AFTER
OPERATION

MAINTENANCE

FRENCH AND SPANISH LANGUAGE SECTIONS.
 Push the accessory securely into place.
 When not in use, remove and store the accessory and
adaptor.
REMOVING/REATTACHING THE DUST BOWL
See Figures 4 - 6, page 6.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
CLEANING/REPLACING THE FILTER
See Figures 4 - 5, page 6.
 Remove the battery pack.
 Depress the release button located on top of the hand
vac.
 Remove dust bowl, filter housing, and filter from vacuum.
 Remove filter housing and filter from dust bowl.
 Turn filter counterclockwise and remove it from filter
housing.
NOTE: To reassemble, insert filter into filter housing and
turn clockwise to lock into place.
 Shake or lightly brush any dust or dirt off the filter.
 Shake or lightly brush any dust off the filter housing. Wash
if necessary.
 Empty the dust bowl; wash if necessary. Before reattach-
ing to the hand vac, make sure all pieces are completely
dry.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing replacement filter, request recommended
part number 019183001012.
5 — English