Cub Cadet LTX 1146KW Operator's Manual page 14

Drive Pedal
The drive pedal is located on the right side
of the tractor, along the running board. Press
the drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled
with the drive pedal. The further forward that
the pedal is pivoted, the faster the tractor
will travel. The pedal will return to its original
position when it's not pressed.
Reverse Pedal
The reverse pedal is located on the right side of
the tractor along the running board. Ground
speed is also controlled with the reverse pedal.
The further downward the pedal is pivoted,
the faster the tractor will travel. The pedal will
return to its original position when it's not
pressed.
Brake
If the Brake light illuminates when attempting to start the
tractor's engine, depress the brake pedal.
Electric PTO (Blade Engage) Knob
To engage the power to the cutting
deck or other (separately available)
attachments on models equipped
with an electric PTO, pull outward
on the PTO (Blade Engage) knob.
Push the PTO (Blade Engage) knob
inward to disengage the power to
the cutting deck.
NOTE: The PTO (Blade Engage) knob
must be in the disengaged (OFF)
position when starting the engine,
when traveling in reverse and if the
operator leaves the seat.
Cargo Net
The cargo net is located on the lower half of the dash and can be
used for storage.
14 S 4— c
ection ontrolS and
(If Equipped)
F
eatureS
Fuel Level Indicator
The Fuel Level Indicator is located on the left side of the
tractor's dash and indicates the amount of fuel in the gas
tank.
PTO/Blade Engage Handle
Activating the PTO engages power to the cutting deck or other
(separately available) attachments. Push forward on the
PTO/Blade Engage handle to activate it. Pull the PTO/Blade
Engage handle back to disengage the power to the cutting deck
or other (separately available) attachments.
NOTE: The PTO/Blade Engage handle must be in the disengaged
(OFF) position when starting the engine.
Parking Brake/Cruise Control Lever
Located in the center of the tractor's dash panel below the
steering wheel, the Parking Brake/Cruise Control lever is used
to engage the parking brake and the cruise control. Refer to
the Operation section of this manual for detailed instructions
regarding the parking brake.
NOTE: The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
NOTE: Cruise control can NOT be engaged at the tractor's
fastest ground speed. If the operator should attempt to do so,
the tractor will automatically decelerate to the fastest optimal
mowing ground speed.
WARNING!
Never leave a running machine
unattended. Always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
(If Equipped)