Intex Krystal Clear SF10220 Owner's Manual page 16

SAND FILTER PUMP HOSE CONNECTION SETUP (continued)
For NON-INTEX pool:
Connect the hoses to the prefilter inlet and 6-way valve outlet with an adaptor A (36).
Tighten securely. Remove the drain cap (3) before attaching the drain/waste hose
or pipe.
36
3
For INTEX pool size 16' and below:
1. In a counter-clockwise motion unscrew plunger valve union from the threaded
strainer connector (26). Be careful not to lose the step rubber washer (23).
2. Grasp the plunger valve assembly. Make sure the step washer (23) is in place.
Connect adaptor B (28) to plunger valve union.
3. Remove wall plug and then insert the strainer (29 & 31) into the lower position
of protruding hose connection, and the nozzle (29 & 30) into the upper position
of protruding hose connection. Adaptor B (28) fits over the strainer
connection (29) inserted into the connection. Tighten securely.
4. Remove the drain cap (3) before attaching the drain/waste hose or pipe.
3
SAVE THESE INSTRUCTIONS
(179FR) MODEL SF10220 SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 08/24/2012
Hose ID 1-1/4" (32mm)
/ 1-1/2" (38mm) with
clamp
POOL
36
English
Hose ID 1-1/4" (32mm)
/ 1-1/2" (38mm) with
clamp
29 & 30
POOL
29 & 31
Page 16
179
FR