Pyle PGTAMPL100 User Manual

30 Watt Guitar Amplifier
8'' Speaker with Volume, Bass, Treble,
Gain and Digital Reverb Controls
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Before going any further, make sure that your ampli er is compatible
with your mains electricity supply.
1. Ensure that the MAINS (power) switch is set to the OFF position.
2. Connect the supplied mains (power) lead into the mains electricity supply.
3. Ensure that the VOLUME controls are set to zero.
4. Plug your guitar into an INPUT jack socket.
5. Turn the front panel MAINS switch to the ON position.
6. Turn the VOLUME up to your preferred level and your ampli er is ready to play.
Function
1 2
1-2. HIGH and LOW INPUT: Input for your guitar. Use a good quality guitar cable
(i.e. one that's screened/shielded) to help prevent noise, interference and
unwanted feedback.
3. GAIN: This control sets the operating level of the pre-amp. Simply turn up the Gain
control until the required amount of distortion is achieved.
4. SELECT: Select the drive channel or normal channel.
5. TREBLE: Increasing the Treble will make your sounds brighter and more cutting,
turning it down will decrease your tone's edge and make it sound softer as a result.
6. MIDDLE: Adjusts the sound level of middle-frequency range.
7. BASS: Adjusts the sound level of the low-frequency range.
8. LENGTH: This equalization controls reverb length
9. DEPTH: This equalization controls reverb depth
10. VOLUME: This is the overall level control for the normal channel.
www.PyleUSA.com
3 5 6
4
7 8 9 10 11 12 13