Table of Contents
Advertisement
0335E2new.fm Page 13 Tuesday, April 25, 2000 4:10 PM
U
SING THE
R
EMOTE TO
C
ONTROL
VCR
AND
C
ABLE
B
OX
F
UNCTIONS
Operating the Precoded Function
for Your VCR
This remote is designed to operate
different types of VCRs. You must first
program the remote to match the
remote system in your VCR. (Refer to
the VCR Code Index section.)
1. Turn on your VCR.
2. Aim the remote control at the front
of your VCR.
3. Press the VCR button to switch to
VCR precoded mode.
4. While holding down the VCR
button, enter the 2-digit preset
code that matches your VCR*. The
remote will turn on your VCR when
the correct 2-digit preset code is
entered. When this occurs, the
remote control is programmed for
your VCR. If your VCR does not
turn off after 5 seconds, try a
different 2-digit preset code.
5. The remote will now control your
VCR.
NOTES:
•
If your VCR cannot be operated
after
performing
procedures, this means that your
VCR
codes
precoded into the remote.
•
In the unlikely event that your VCR
cannot
performing the above procedures,
consult your VCR operating guide.
•
The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
•
If your VCR does not have a power
function, the remote will issue the
CHANNEL UP function.
Get user manuals:
See SafeManuals.com
Using the Remote to Control VCR and Cable Box Functions
the
above
have
not
been
be
operated
after
POWER
TV
CABLE
VCR
1
2
3
CH
4
5
6
CH
7
8
9
VOL
0
MUTE
LTS-CH
VOL
INPUT
SLEEP
CURSOR
CONTROL
MENU
RECALL
REC
STOP
PAUSE
tt
t
uu
TV/VCR
HITACHI
CLU-351U
* (Codes are listed on page 14)
- 13 -
Operating the Precoded Function
for Your Cable Box
1. Turn on your cable box.
2. Aim the remote control at the front
of your cable box.
3. Press the cable box button to
switch to cable box precoded
mode.
4. While holding down the CABLE
button, enter the 2-digit preset
code that matches your cable box*.
The remote will turn on your cable
box when the correct 2-digit preset
code is entered. When this occurs,
the remote control is programmed
for your cable box. If your cable
box does not turn off after 5
seconds, try a different 2-digit
preset code.
5. The remote will now control your
cable box.
NOTES:
•
If your cable box cannot be
operated
after
performing
above procedures, this means that
your cable box codes have not
been precoded into the remote.
•
In the unlikely event that your
cable box cannot be operated after
performing the above procedures,
consult your cable box operating
guide.
•
The remote control will remember
the codes you have programmed
in until the batteries are removed.
After replacing the batteries repeat
the entire programming procedure
stated above.
•
If your cable box does not have a
power function, the remote will
issue the CHANNEL UP function.
•
For some models, the remote
control's channel
and
control the cable box channel. The
number buttons will control your
television channel although you
are in cable mode.
the
will
Advertisement
Table of Contents
