Table of Contents
Advertisement
CAUTION
• When threading the needle, be sure that you
have touched
lock all keys and buttons, otherwise injuries
may occur if the "Start/Stop" button or any
other button is pressed and the machine starts.
d
Raise the presser foot lever to raise the presser foot.
Memo
• If the presser foot is not raised, the machine cannot
be threaded.
Remove the spool cap and place the spool of thread
e
onto the spool pin.
Slide the spool onto the spool pin so that the thread
unwinds to the front from the bottom.
1 The thread unwinds to the front from the bottom.
Slide the spool cap onto the spool pin.
f
Slide the spool cap as far as possible to the right, as
shown, with the rounded side on the left.
CAUTION
• Choose a spool cap that best fits the size of
spool being used. For more information
regarding the choice of spool caps for your
thread choice, refer to "Note" on page 15.
If the spool or the spool cap is not positioned
correctly, the thread may become tangled
around the spool pin or the needle may break
and cause injury.
on the operation panel to
1
g
While holding the thread near the spool, pass the
thread through the thread guide cover. And then, pass
the thread under the thread guide plate, and pull it up.
1
1 Thread guide cover
2 Thread guide plate
h
While holding the thread passed under the thread
guide plate, pass the thread through the thread channel
in the order shown below.
Note
• If the presser foot has been lowered and the
shutter is closed, the machine cannot be threaded.
Be sure to raise the presser foot to open the shutter
before threading the machine. In addition, before
removing the upper thread, be sure to raise the
presser foot to open the shutter.
• This machine is equipped with a window that
allows you to check the position of the take-up
lever. Look through this window and check that the
thread is correctly fed through the take-up lever.
i
Slide the thread behind the needle bar thread guide.
The thread can easily be slid behind the needle bar
thread guide by holding the thread in your left hand,
then feeding the thread with your right hand, as shown.
Make sure that the thread is passed through to the left of
the tab of the needle bar thread guide.
2
1
Upper Threading
1
2
1 Needle bar thread
guide
2 Tab
19
Advertisement
Table of Contents
