Sennheiser MKE 600 Instruction Manual page 6

f Set the battery switch
battery switch to
3
The LED 3 provides the following information:
LED
lights up red for approx. 1 second
after switch-on and then goes off
lights up red permanently
flashes briefly red on switch-on
When not using the microphone for extended periods of time, remove the
battery to prevent self-discharge.
„Low Cut" verwenden
f Set the "Low Cut" switch
2
Switch position Frequency response of the microphone
MKE 600
4 to ON to switch the internal battery on or set the
OFF to switch the battery power off.
4
2 to the desired position.
linear frequency response
frequencies below 100 Hz are attenuated to reduce
wind and impact noise
Internal battery power
switched on; operating time: up to
approx. 150 h
"Low Batt", battery is almost empty;
approx. 8 h of remaining operating
time after initial display
battery is empty; the microphone is
not operational