NANOLUX LED PAD1200 Operating Manual

ALWAYS COMPLY WITH LOCAL
INSTALLATION REGULATIONS AND CODES
The fixture is suitable for indoor environment. Do not install your fixture in wet or
outdoor environment. Do not operate the fixture close to combustible materials. The
fixture will get hot during operation. Do not touch the fixture during or right after
operation. Make sure the power cord does not touch any hot part of the fixture. Make
sure the light bars are clean and inserted correctly. The normal operating environment
temperature should be below 104°F. Exceeding the maximum environmental
temperature will stress electronic components, which will lead to shorter lifetime and
decreased reliability.
TROUBLE SHOOTING
Problem Probable cause(s)
corrective maintenance
One or more
Make sure power is on and
fixtures are Disconnect from power source.
cables are plugged in.
completely off.
Broken cable or wire connecting
Repair or replace any
Dimming
controller to fixture or wire
damaged cables if necessary.
failure
connecting fixture to fixture.
The power supply settings do Disconnect fixture from the
LED PAD will
not match with local AC power supply. Check settings
not come on.
voltage and frequency. and correct if necessary.
SCOPE OF USE AND MAINTENANCE
● Comply with local installation regulations.
● Store the fixture in a dry and clean environment, with an ambient temperature of
-10°C ~ 50°C and ambient humidity of less than 90% RH. It is recommended that
the fixture shall not stay unused for more than six months. If it has stayed unused
for more than six months, please test to ensure fixture is functioning at 100%.
● Please keep products safe. Avoid mechanical pressure, excessive vibration and
dropping the unit during the process of assembly to protect the light bar and track.
● Keep away from water, oil and organic solvent, or it will reduce the efficacy and have
the potential risk of electric leakage.
● All equipment, devices and machines shall be effectively grounded.
● Regularly check and clean the dust from LED PAD.
1. Disconnect from power supply before general care.
2. Remove the dust from the LED PAD by using low-pressure compressed air.
3. Clean the diode array with a soft cloth to prevent it from being scratched.
4. Be sure not to touch the diode with your bare hands, even after the LED PAD is
disconnected from power supply.
● It is recommended that you contact a licensed electrician or an expert if any of the
following happens:
1. The cable or the plug has been damaged.
2. The unit has been exposed to rain.
3. Significant changes in the unit performance.
4. Fixture dropped and corner of its enclosure got bent.
● There are no serviceable parts inside the LED PAD. Opening the LED PAD will void
its warranty.
WARRANTY
Nanolux warrants manufacturing defects of this product if it is used under normal
operating conditions for a period of five (5) years from the original date of purchase. If
the product shows manufacturing defects within this period and that defect is not
caused by user error or improper use, Nanolux shall, at its discretion, either replace
or repair the product by using applicable new or refurbished parts. For any service,
return the product to your shop along with the original sales receipt.
-04-
Possible fixes or
PATENTED PRODUCTS, COUNTERFEITING NOT ALLOWED.
Designed by NANOLUX in California
Made in China
OPERATING
MANUAL
LED PAD1200
&
LED PAD720
NCCS-RTU/0-10V COMPATIBLE