Table of Contents
Advertisement
12 - FACTORY OPTIONS AND ACCESSORIES
This manual and the manufacturer's manual must be kept
with care. If it is lost or damaged, please contact the Technical
Assistance Service for a new copy.
The thermal module, before being connected to the hydraulic
system, the gas network, and the electrical system, may be
exposed to temperatures ranging from 4°C to 40°C. After it can
activate the Frost Protection function.
Regularly check that the condensate drain is free from
obstruction.
We recommend cleaning inside the exchanger once a year,
extracting jet and burner and removing any installation debris
by suction. This operation will be done by personnel from the
Technical Assistance Service only.
■ Basic safety rules
The operation of any appliance that uses fuel, electrical power
and water demands that a number of fundamental safety
precautions be respected. It is forbidden:
- To use electrical devices or equipment, such as switches,
appliances, etc. if there is a smell of gas or unburnt products.
If so:
• Close the fuel shut-off cock.
• Report the fault immediately to the Technical Assistance
Service or a professionally qualifi ed heating engineer.
• Any technical or cleaning activity is forbidden before
disconnecting the boiler from the main power supply by
switching the magnetothermic switch placed in the electrical
cabinet of the 50FF/FC unit.
- To tamper with or adjust the safety or control devices without
prior authorisation and instructions from the manufacturer.
- To pull, disconnect, or twist the electrical cables coming from
the boiler even if it is disconnected from the mains electricity
supply.
- To plug or block the condensate drain outlet
- To switch off the appliance if the outdoor temperature may
drop to below ZERO (frost hazard).
- To activate the thermal module without water.
■ Safety devices
The triggering of safety devices indicates the malfunction of
a potentially hazardous thermal module. Therefore, contact
Technical Assistance Service immediately. After a brief pause,
it is possible to try and restart the appliance.
Safety devices must be replaced by Technical Assistance
Service, using only original parts. Refer to the spare parts
catalogue supplied with the appliance. After making the repair,
check that the appliance is working properly.
The appliance must not be put in service, even temporarily,
when tampered safety devices are not in operation or have
been tampered with.
Identifi cation of the boiler
The boiler can be identifi ed as follows:
50
1- Technical data plate:
This plate indicates the technical and performance data.
CONDEXA PRO 100
Cod.
T067692GE
Key:
Central heating section
Qn
Rated heat input
Pn
Rated useful heat output
IP
Electric degree of protection
Pmw Maximum operating pressure, DHW circuit
Pms Maximum operating pressure, CH circuit
T
Temperature
Effi ciency
ɳ
D
Specifi c fl ow rate
NOx NOx class
2- Gas label:
Is located on the appliance's side and states the type of fuel used
and the country of destination:
Country
Italy, Ireland,
Great Britain,
Portugal,
Slovenia,
Slovakia, Greece
Spain
Romania,
Bulgaria,
Turkey, Denmark,
Estonia, Sweden,
Norway, Latvia,
Lithuania,
Finland, Russia,
Hungary
Poland
Croatia
Holland
Czech Republic,
Austria,
Switzerland
Luxembourg
2
Belgium
1
France
Malta, Cyprus,
Iceland
Germany
Gas type:
IT: G20=20 mbar G30=28-30 mbar G31=37 mbar
RIELLO S.p.A.
Via Ing.Pilade Riello, 7
37046 Legnago (VR) -
Caldaia a condensazione - Chaudierè a condensation - Brennwertkessel - Condenserende verwamingsketel
X0D
IP
P.min.G20= 20 mbar
20115226
FC145000263
N°
Qn(min)=
230V ~ 50Hz 150 W
Pn(min)=
Qn(max)=
Pn(max)=
T=90°C
B23-B53-B53p (C63, C63X)
PMS=
6
bar
Category
Gas
Pressure
(mbar)
II2H3+
G20
20
II2H3+
G20
18
II2H3B/P
G20
20
II2H3B/P
G20
25
II2H3B/P
G20
25
II2H3B/P
G20
20
II2H3B/P
G25
25
II2H3B/P
G20
20
II2H3B/P
G20
20
II2E3P
G20
20
I2E(S)
G20/G25 20/25
I3+
--
--
II2E+3+,
G20/G25 20/25
I3B/P
--
--
II2ELL3B/P G20/G25 25
Category:
II2H3+
0085 /
17
0085CP0214
European Directive
92/42/EEC:
G20
G25
19,4
-
NOx:
5
kW
kW
19,0
-
kW
kW
97
-
kW
kW
-
95,16
kW
kW
Gas
Pressure
(mbar)
G30/G31 28-30/37
G30/G31 28-30/37
G30
30
G30
30
G30
37
G30/G31 30
G30
30
G30
50
G30
50
G31
37
--
--
G30/G31 28-30/37
G30/G31 28-30/37
G30
30
G30
50
Hide quick links:
Advertisement
Table of Contents
