Features; Assembly; Operation - Ryobi PCL525 Operator's Manual

PRODUCT SPECIFICATIONS
Length of Stroke ........................................................... 1 in.
Strokes Per Minute ........................... 0 - 3,000 /min. (SPM)
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1.Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

FEATURES

Cutting Angle ................................0° to 45° (Left and Right)
Orbital Motion ......................................................4 Settings

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

WARNING:
To avoid possible serious injury, keep hands and fingers
away from the area between the gear housing and saw
blade clamp.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
paneling, composition board and hard board)
 Cutting thin sheet metal
 Cutting plastics and laminates.
SWITCH TRIGGER
See Figures 1 and 2, page 11.
The lock-out button, located on the handle above the switch
trigger, reduces the possibility of accidental starting.
 To turn the saw on: Slide lock-out button to the unlocked
position, and press the switch trigger.
 To turn the saw off: Release the switch trigger.
6 - English