Yamaha XSR MTM690 2016 Service Manual page 208

TIP
• Lubricate the end of the throttle cables and the
inside of the throttle grip with a thin coat of lith-
ium-soap-based grease.
• Align the projection "a" on the throttle cable
housing with the hole "b" in the handlebar.
• There should be 1–3 mm (0.04–0.12 in) of
clearance "c" between the throttle grip and the
grip end.
b
a
7. Install:
• Handlebar switch (right) "1"
Handlebar switch screw (right)
2.0 Nm (0.20 m·kgf, 1.4 ft·lbf)
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
1
8. Install:
• Throttle cable holder 1 "1"
• Throttle cable holder 2 "2"
TIP
• Make sure that the throttle cable holder 1 "1"
contacts the throttle cable adjusting nut and
that the open ends of the holder are pointing
rearward.
• Align the throttle cable holder 2 "2" with the
edge "a" of the front brake master cylinder.
c
2
1
2 LS
b
a
9. Install:
• Front brake master cylinder assembly
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-41.
10.Adjust:
• Throttle grip free play
Refer to "CHECKING THE THROTTLE GRIP
OPERATION" on page 3-27.
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
11.Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-12.
Clutch lever free play
5.0–10.0 mm (0.20–0.39 in)
4-69
HANDLEBAR
2
a
1