CITROEN AMI 2021 Handbook page 32

Table of Contents

Advertisement

In the event of a breakdown
Take used remote control batteries and
vehicle batteries to a special collection point.
Protect your eyes and face before
handling the battery.
All operations on the battery must be carried
out in a well ventilated area and away from
naked flames and sources of sparks, to avoid
any risk of explosion or fire.
Wash your hands afterwards.
Flat 12 V battery
It is no longer possible to start the motor
or recharge the traction battery.
Before working on the 12 V battery
Switch off the ignition, apply the parking
brake, check that the instrument panel is off
and that the charging cable is not connected.
Recharging the 12 V battery
Do not recharge the battery without first
disconnecting the terminals and removing the
battery.
Do not disconnect the battery terminals while
the READY indicator lamp is lit, or while the
vehicle is charging.
Jump-starting another vehicle
Do not use the 12 V battery to jump-start
another vehicle or to charge another vehicle's
battery.
30
Symbols
No sparks or naked flames, no smoking.
Always protect your eyes. Explosive
gases can cause blindness and injury.
Keep the vehicle's battery out of the reach
of children.
The vehicle's battery contains sulphuric
acid which can make you go blind or
cause severe burns.
For more information, refer to the
handbook.
Explosive gases can be present close to
the battery.
www.carobook.com
Removing/Refitting
Removing rear bumper
► Remove the number plate lamp prior to
starting.
For more information on the Number plate
lamp, refer to the corresponding section.
► Pass the lamp's suspended wiring loom
behind the bumper.
► Remove the 2 lower fixing screws from the
frame.
► Remove the 2 upper access flaps from the
wings, pass an arm under the wing and lift it up.
► Remove the 2 upper side fixing screws from
the flaps.
► Remove the 2 lower side fixing screws from
the wheel arches.
► Pull the bumper horizontally for about ten
centimetres until the attachment points come
away.
► Disconnect the indicator wiring looms.

Advertisement

Table of Contents
loading

Table of Contents