Installation - Clarion DPH910 Owner's Manual

5. INSTALLATION

1. Before starting, be sure to disconnect the
battery's negative "−" terminal to prevent ac-
cidents due to short-circuits.
2. Location
Consider safety and operability when select-
ing a place for installation. Avoid the following.
• Locations where the unit will hamper driving.
• Locations where the unit could injure passen-
gers if the car stops suddenly.
• Locations exposed to direct sunlight or hot air
from the heater, etc.
• Locations where the unit may be exposed to
rain or water.
Installation example
Note: Please read this chapter referring to "2. INDENTIFICATION OF PARTS" at the beginning of this manual.
1. Attach the mounting brackets 5 to the sides
of the DPH910 using the screws 8 provided.
2. Select the location on the floor mat. Drill holes
in the floor mat to match the positions of the
holes in the mounting brackets 5.
3. Insert the canoe clips 7 from the rear of the
floor mat and install the DPH910.
∗ There are three mounting holes on each side
of the DPH910. Select the appropriate holes
to match to the installation location.
10
DPH910
3. Be sure to use the included screws and brack-
ets. Screws other than those supplied could
damage the unit.
4. When drilling holes in the dashboard, etc., be
sure to check beforehand that there are no
harnesses or other wires on the inside.
(Installing the unit under the driver's seat)
@@@@@@@@@@@@
@@@@@@@@@@@@
@@@@@@@@@@@@
@@@@@@@@@@@@
@@@@@@@@@@@@
Case Case
Damage
8mm max.