Battery Status Indication - Master WiControl Manual For Installation And Use

4. BATTERY STATUS INDICATION

The level of the battery charge is measured at each passage from the standby state to the
wait state. The level is shown on the display using the battery indicator:
Level above 2.6V:
Level between 2.4V and 2.6V: 2 bars lit
Level between 2.2V and 2.4V: 1 bar lit
Level below 2.2V:
Environmental problem
All materials used in the manufacture of this appliance are recyclable.
We recommend that the device itself, and any accessories, packaging, etc.
be sent to a centre for ecological recycling as established from laws in force
on recycling.
The device is mainly made from the following materials:
Iron
various type
Dispose materials in conformity with local regulations about removal.
Recall to main principles of warranty certificate
The manufacturer will guarantee good function of the appliance. The
manufacturer shall undertake to replace defective parts due to poor quality
materials or manufacturing defects.
The guarantee covers products and individual parts for 2 years from the date of
purchase. The latter is valid as long as the purchaser possesses proof of
purchase and completion of all agreed conditions of payment.
Guarantee of good function of appliances agreed by the manufacturer implies that
the latter undertakes to repair or replace free of charge and in the shortest period
possible any parts that break while under warranty. The purchaser is not entitled
to any reimbursement for eventual direct or indirect damage or other expenses
incurred. Attempt to repair by personnel unauthorised by the manufacture shall
render the warranty null and invalid.
The warranty does not cover fragile parts or parts subject to natural wear and tear
or corrosion, overload, however temporary etc. The manufacturer will accept no
responsibility for eventual damage incurred by erroneous assembly, manoeuvre
or insertion, excessive stress or inexpert use.
Repairs performed under guarantee are always "ex-factory of the manufacturer".
Respective transport expenses (out/back) are the responsibility of the purchaser.
The total or partial removing of the sticker label (with the identification code of the
article) invalidates the warranty.
Before the intervention of an authorized technician, the buyer has to prove the
presence of the original power cable, that must be no shorter than 30 cm.
MASTER S.r.l. – I422E - 23/11/2017
Master Srl may not be held liable in any way whatsoever for any inaccuracies due to printing or data transcription errors in this document.
3 bars lit
0 bars lit – all off
Aluminium Cuprum Zinc Silicon Plastic of
Pagina 13