Assembly; Installation - Craftsman 919.165613 Owner's Manual

Hide thumbs Also See for 919.165613:
Table of Contents

Advertisement

Available languages

Available languages

Contents of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Operator's Manual
1 - Parts Manual
4 - 5/8" Washers
Tools Required for Assembly
1 - 9/16" socket or open end
wrench
1 - Electric drill
Unpacking
1.
Remove all packaging.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
Locate the air compressor in a
clean, dry, and well ventilated
area.
Located the air compressor at
least 12" (30.5 cm) away from the
wall or other obstructions that will
interfere with the flow of air.
Locate the air compressor as
close to the main power sup-
ply as possible to avoid using
long lengths of electrical wiring.
NOTE: Long lengths of electrical
wiring could cause power loss to
the motor.
The air filter must be kept clear of
obstructions which could reduce
air flow to the air compressor.
Anchoring of the Air Compressor
can weaken the air tank and cause
an explosion. The compressor must
be properly mounted.
The air compressor MUST be bolted to
a solid, level surface.
N004083

ASSEMBLY

iNSTALLATioN

Risk of Bursting.
Excessive Vibration
be necessary to brace or support
one side of the unit when removing
the pallet because the air compres-
sor will have a tendency
to tip.
2.
Remove and discard the (4)
screws and washers holding the
compressor to the pallet.
3.
With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
Hardware needed:
4 - Concrete anchors
(not supplied)
4 - 3/8" Lag screw to fit concrete
anchors
(not supplied)
4 - 5/8" Washer (supplied)
shims (if needed)
1.
Place the air compressor on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install concrete
anchors.
4.
Line-up holes in surface with holes
in air compressor feet.
5.
Place the (4) washers (supplied)
between the floor and air com-
pressor feet. If needed, solid
shims may be placed between the
washers and floor to evenly dis-
tribute weight on all four feet. See
next figure.
10- ENG
Risk of Unsafe
Opertation. It may

Advertisement

Chapters

Table of Contents
loading

Table of Contents