Advertisement
Available languages
Available languages
All manuals and user guides at all-guides.com
R R e e a a r r P P a a n n e e l l
4
2
1
3
A A C C P P O O W W E E R R F F E E A A T T U U R R E E S S : :
1 1 . . R R E E M M O O V V A A B B L L E E A A C C P P O O W W E E R R C C O O R R D D
This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the line cord to
this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line
voltage is used. (See voltage marking on unit.) Never remove or cut the ground pin of the line cord plug. This unit
is supplied with a properly rated line cord. When lost or damaged, replace this cord with one of the proper
ratings.
N N O O T T E E : : F F O O R R U U K K O O N N L L Y Y
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be
connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and
yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or
the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the
letter L or color red.
2 2 . . P P O O W W E E R R S S W W I I T T C C H H
This switch is used to turn the MAX 450 on or off. To turn the unit on, flip the switch to the "on" position.
3 3 . . G G R R O O U U N N D D P P O O L L A A R R I I T T Y Y S S W W I I T T C C H H
Three-position, rocker-type switch, which for most applications should be operated in the center (zero) position. If
hum or noise is present with the ground switch in the center position, place the ground polarity switch to positive
or negative (+ or -) to minimize hum; should a problem continue, consult your authorized Peavey dealer, the
Peavey factory, or a qualified service technician. N N o o t t e e : : The ground switch is not available on 220/240 volt models.
4 4 . . F F U U S S E E
The fuse is located within the fuse holder on the rear of the unit. If the fuse should fail, I I T T M M U U S S T T B B E E R R E E P P L L A A C C E E D D
W W I I T T H H T T H H E E S S A A M M E E T T Y Y P P E E A A N N D D V V A A L L U U E E I I N N O O R R D D E E R R T T O O A A V V O O I I D D D D A A M M A A G G E E T T O O T T H H E E E E Q Q U U I I P P M M E E N N T T A A N N D D T T O O P P R R E E V V E E N N T T V V O O I I D D I I N N G G
T T H H E E W W A A R R R R A A N N T T Y Y . If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair.
N N O O T T E E : : T T H H E E F F U U S S E E S S H H O O U U L L D D O O N N L L Y Y B B E E R R E E P P L L A A C C E E D D W W H H E E N N T T H H E E R R E E M M O O V V A A B B L L E E P P O O W W E E R R C C O O R R D D H H A A S S B B E E E E N N D D I I S S C C O O N N N N E E C C T T E E D D
F F R R O O M M I I T T S S C C H H A A S S S S I I S S R R E E C C E E P P T T A A C C L L E E ( ( 1 1 ) ) . .
5
Advertisement
