Set Up Gps Connection; Positioning Settings; Hold Your Device Correctly - Nokia N6210 Manual

To use A-GPS, you must have a packet data internet access
point defined. Your device asks for the internet access
point when A-GPS is used for the first time. To define the
access point, see "Positioning

Set up GPS connection

Positioning settings

Select > Settings > Phone sett. > General > Positioning
and from the following:
Positioning methods — to enable or disable different
positioning methods
Positioning server — to edit positioning server settings.
To select whether to allow automatic connections to the
positioning server, to be asked every time, or to never
connect to the positioning server, select Positioning server
use. To define an access point for A-GPS, select Access
point. Only a packet data internet access point can be
used. Your device asks for the internet access point when
A-GPS is used for the first time. To define the server used,
select Server address.
Notation preferences — to define the measurement system
and coordinate format
settings", p. 40.
Copyright © 2008 Nokia. All rights reserved.

Hold your device correctly

When using the receiver, from an upright position, move
the device to an angle of about 45 degrees, with an
unobstructed view of the sky.
Establishing a GPS connection may take from a couple of
seconds to several minutes, even longer in a vehicle.
See "GPS light", p. 19.
Using the GPS receiver may drain the device battery
faster.
If your device cannot find the satellite signal, consider the
following:
• If you are indoors, go outdoors to receive a better
signal.
• If you are outdoors, move to a more open space.
• Check that your hand does not cover the GPS receiver
of your device.
• If the weather conditions are bad, the signal strength
may be affected.
• Some vehicles have tinted (athermic) windows,
which may block the satellite signals.
40