To Register The Magic Lighting Remote; To Re-Register The Magic Lighting Remote - LG CineBeam HU915QE Owner's Manual

22

To Register the Magic Lighting Remote

You must pair the Magic Lighting Remote with the projector to use it.
Pair the Magic Lighting Remote prior to use as follows.
1
Put batteries into the Magic Lighting Remote and turn the Projector on.
2
Point the Magic Lighting Remote at your projector and press the
(OK) on the remote control.
• If the projector fails to register the Magic Lighting Remote, try again after
turning the projector off and back on.

To Re-register the Magic Lighting Remote

1
Press the and
the Magic Lighting Remote with your projector.
2
Press the Wheel (OK) button towards the projector to re-register the
Magic Lighting Remote.
•
Hold the remote control towards the projector and press the
Settings) buttons at the same time more than 5 seconds until instructions
appear. The previously registered remote control is deregistered and then
registered again.
buttons at the same time, for five seconds, to unpair
Wheel
(Q.
and