Connecting The Speakers - JVC UX-7000R Instructions Manual

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

1. Open the Speaker terminals on the rear of the Unit, and on the Speakers themselves.
2. Connect the speaker cords between the terminals as shown below.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
Close each of the terminals to securely connect the cordsï
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Removing the speaker grilles
7KHýVSHDNHUýJULOOHVýFDQýEHýUHPRYHGï
When removing,
ìï ,QVHUWý\RXUýILQJHUVýDWýWKHýWRSýDQGýSXOOýWRZDUGVý\RXï
ëï $OVRýSXOOýWKHýERWWRPýWRZDUGVý\RXï
Connecting an MD Recorder/Tape Deck
&RQQHFWýõRSWLRQDOôýVLJQDOýFRUGVýEHWZHHQýWKHý6\VWHP©Vý0'î7$3(ý,1î287ýWHUPLQDOVýDQGýWKHýRXWSXWîLQSXWýWHUPLQDOVýRIýWKHýH[WHUQDOý0'ýUHFRUGHUñ
WDSHýGHFNñýHWFï
You can then listen to the external source through the System, or record the System's CD player or tuner to the external uniWï
R
4
Right speaker (rear side)
Marked with a black line
SPEAKER CORD
Signal cord (optional)
L
Pin-plug x 2
IN
MD/TAPE
OUT
Signal cord (optional)
Pin-plug x 2
Left speaker (rear side)
When attaching the speaker grille
Speaker grille
MD recorder or tape deck (optional)
Pin-plug x 2
Pin-plug x 2