Installing Power, Ground, And Alarm Cables; Reference Material - Fujitsu FLASHWAVE 7500 Installation Manual

CHAPTER 2
Core Configuration

Installing Power, Ground, and Alarm Cables

2.10

Installing Power, Ground, and Alarm Cables

This procedure provides instructions for installing power, ground, and alarm cabling for
standard rack configurations.
N .
O
2.10.1
2.10.2
2.10.1

Reference Material

The cables and cable harnesses used are listed in
[p. 2-38].
Note: Connections to the shelf power terminal strip should use copper conductors only.
Figures 2-22 [p. 2-39] through 2-24 [p. 2-41]
and alarm cabling between the rack, shelves and CBP for the following standard rack
configurations:
Rack with one Universal shelf
■
Rack with two Universal shelves
■
Rack with three Universal shelves
■
Each standard rack configuration includes a circuit breaker panel (CBP) with power terminals
as shown in
shelves listed in
Figure 2-26 [p. 2-43]
shows the power cabling.
Figure 2-28 [p. 2-45]
CBP. Connectors along this harness mate to shelf alarm cables (see
plug into alarm ports on the shelf backplane.
FLASHWAVE 7500 Release 6.1
2-36
Equipment Installation
Revision 1, June 2009
It includes the following subprocedures:
S
UBPROCEDURE
Reference Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing Power, Ground, and Alarm Cables. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 2-25 [p. 2-42]. The circuit breakers within the CBP are associated with
Table 2-2 [p. 2-42].
shows the Optical/Tributary shelf backplane.
shows the rack alarm cable harness, which gets wire wrapped to the
Fujitsu and Fujitsu Customer Use Only
Table 2-1 [p. 2-37]
show schematics for installing power, ground,
(Figure 2-22 [p. 2-39])
(Figure 2-23 [p. 2-40])
(Figure 2-24 [p. 2-41])
e u r e d
P
AGE
2-36
2-47
and shown in Figure 2-21
Figure 2-27 [p. 2-44]
Figure 2-29 [p. 2-46]) that
FNC-7500-0061-200
Issue 1, May 2009
o c P r