Table of Contents
Advertisement
Available languages
Available languages
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D.
and fittings should have 1/4" NPT thread.
Operation
Before each use:
Drain water from air compressor tank
l
and condensation from air lines. See
air compressor's operators manual.
the air supply before lubricating or
changing sandpaper disc.
Lubricate tool, see "Maintenance"
l
section in this manual.
Select the required sandpaper pad
l
(A) and sandpaper (B).
Remove pad nut (C).
l
Press pad nut (C) through sandpaper (B) and sandpaper pad (A).
l
Holding hub (D) assemble pad nut with sandpaper and sandpaper pad.
l
Place holding rod (E) into hole located on hub and tighten securely. NOTE: Holding
l
rod (E) is used to tighten or loosen hub.
SPECIFICATIONS
Free Speed (No Load)
Maximum Working Pressure
Pad Diameter
Air Inlet
Recommended Hose Size
Air Consumption @ 90 PSI
Disconnect
the tool from
B
A
ASSEMBLY
OPERATION
Pad
Nut
Sandpaper
Pad with
Sandpaper
A,B
D
5- ENG
18,000 RPM
90 PSI
3", 4.5", and 5.5"
1/4" NPT
3/8" I.D.
12.5 SCFM
Trigger
Regulator
Knob
C
E
Air Inlet
D22719
Advertisement
Table of Contents
