JVC RX-554RBK Instructions Manual page 44

Operating Other Components
IMPORTANT:
To operate JVC video components using this remote control:
• Aim the remote control directly at the remote sensor on the VCR or TV, not on
the receiver.
7 7 7 7 7 After pressing VCR, you can perform the
following operations on the VCR:
3
Starts playback.
4
Rewinds a video tape.
¢
Fast winds a video tape.
7
Stops operation.
8 Pauses. To resume playing, press 3.
You can always do the following on the VCR:
• Change the channels on the VCR using the VCR
CH +/– button.
• Turn on and off the VCR by pressing VCR in
the (Standby/On) section.
7 7 7 7 7 You can always perform the following operations
on the TV:
• Change the TV's input mode to either "TV" or
"VIDEO" using the TV/VIDEO button.
• Change the TV volume using the TV VOL. +/–
button.
• Change the channels on the TV using the TV CH
+/– button.
• Turn on and off the TV by pressing TV in the
(Standby/On) section.
39
Note:
If you choose a source on the front
panel, the remote control will not
operate that source.
Notes:
• If
CD TV VCR AUDIO
DAP MODE 3D-PHONIC SURROUND
TAPE
1 2 3
TUNER/
EFFECT DELAY TEST
BAND 4 5 6
– +
SEA MODE REAR
VCR
7/P 8 9
– +
SEA CENTER
VIDEO
10 +10
PRESET
• If you press the VCR (the one
SOUND
PHONO ONE TOUCH
CONTROL CD-DISC
OPERATION
– +
– +
TV CH VCR CH
– + PTY SEARCH DISPLAY
TV VOL.
TV/
VIDEO
– +
PTY SELECT
– +
VOLUME MUTING
RM-SR554RU REMOTE CONTROL
you press SOUND
CONTROL, you cannot operate
the VCR with this remote
control. If this happens, press
VCR again, so operating
buttons for video components
will work for the VCR.
for the source selection) on the
remote control aiming at a JVC
TV, the TV's input mode will
change to the video input.