User Instructions - ALDI Auto XS User Manual

WET PICK-UP OPERATION
This cleaner requires only a minimum conversion when going from dry to
wet pick-up. Remove the cloth filter. The foam filter must be positioned
over the lid cage while vacuuming liquids. Do not use the reusable cloth
filter for wet pick-up. When picking up several tanks full of liquid, the foam
filter will become saturated and misting may appear in the exhaust air. At
this time, you should dry the foam filter or change to a dry foam filter to
eliminate the misting and possible dripping of liquid around the lid. After
completing a wet pick-up job, raise the hose to drain any excess liquid into
the tank before shutting off. The interior of the tank should be periodically
cleaned.
AUTOMATIC SHUT-OFF
The cleaner is equipped with an automatic shut-off that operates when
picking up liquids. As the level of the liquid rises, an internal float rises
until it seats itself against a seal at the intake of the motor, shutting off
suction. When this happens, the motor will develop a higher than normal
pitch noise. Before continuing use, empty the liquid waste from the tank
as outlined in the previous paragraph.
NOTE:
If accidentally tipped over, the vacuum could close suction. If this occurs,
place vac in upright position and turn switch OFF. This will allow the
float to return to its normal position, and you will be able to continue
operation.
Your AutoXS Wet/Dry Car Vacuum may be emptied of liquid waste by
removing the power head. To empty, stop the motor and remove the
plug from the car receptacle. Remove the power head and deposit the
liquid waste contents in a suitable drain. After the tank is empty, return
the cover to its original position.

User instructions

6