Advertisement
Step 4: Assemble the Desk on a flat, soft surface such as carpet or cloth to prevent scratching the finish
Attach the Metal frame to the Top Frame (P1) fully tighten bolts, as shown below.
(H2)x4
Bolts Ø1/4" x 38mm L
(H3)x4
Lock Washers Ø1/4"
(H4)x4
Flat Washers Ø1/4"
(H5)x1
Allen Wrench M4
H2
H3
Step 5:
1) Turn the assembled table to an upright position.
2) Assembly is complete. Failure to follow these instructions may cause the bolts to miss align during assembly.
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY
SHOULD BE PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY.
ALWAYS CHECK TO ENSURE THAT ALL HARDWARE IS KEPT TIGHTENED.
H4
Thank you for your purchase
Page 3 of 3
Please adjust the Leveler up or down
under each leg until desk is level.
Advertisement
