Advertisement
Atlanta 8 Tent Instructions
Your Tent should have
Flysheet with sewn in groundsheet
•
2 x Inner Tents
•
2 x Inner tent curtain dividers
•
7 poles:
•
5 long Fibreglass poles for the tunnel
o
2 small fibreglass poles for the door canopies
o
Tent Pegs
•
1. Assemble the poles and lay them out on the ground
2. Open out the flysheet and lay it out with the doors pointing in the desired direction
3. Insert the red colour coded poles through the corresponding coded sleeve on the flysheet, (see
fig.1) then insert the blue colour coded poles through their corresponding colour sleeve
4. Loosen any tension straps attached to the Ring & pin system.
5. Insert the metal pin from the ring and pin system into the bottom of the poles (see fig.2)
6. Push these poles into an arch from the opposite ends and locate pole ends into corresponding
metal pin. To avoid excess strain on poles and tent material, it is advisable to have assistance to
hold these poles upright when forming the dome.
7. Clip all flysheet pole clips onto poles (see fig.3).
8. Next take the 2 small fibreglass poles and insert them, once assembled, into the black pole sleeve
above each door. Place one end of the pole into the metal eyelet at the side of the door and then
the other side to secure in place.
9. Start pegging out the tent at the back corners using the pegs supplied.
a.
Pegs should be positioned at a 45° angle to ensure maximum grip (see fig.4).
10. Pull the tent forwards until taut and peg out the corners at the front of the tent. Ensure that the
sides and rear of the tent form straight lines and the groundsheet is flat and wrinkle free. At this
stage, re-peg any corners where the groundsheet may be creased.
11. Peg out the remaining poles and pegging points
12. Peg out ALL guy lines at 45° angle from the tent
13. To hang the inner tent start at the back and connect the rear floor clips to the loops attached to
the groundsheet. Work up the inner tent connecting all the rear connectors, then connect the
front tension straps and connecters. (Several of the clips should be colour coded to help identify
the correct position). Insert the divider curtains if required.
Fig 1
Fig 2
Fig 3
www.royal-leisure.co.uk
Fig 4
Advertisement
