Important Safety Instructions - Harman JBL LINK MUSIC Quick Start Manual

ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
For all products:
1. Read tlwse instraction5.
2. Keep these iostfllctlons.
3. Heed all warnings.
4.
Follow all instfllctlons.
5. Do not use this apparatus near water.
6. Oean only with a dry cloth.
7. Do not block any ventilation openings. Install this apparatus in accordance with the
manufacturer's Instructions.
8. Do not install this apparaM near any heat sources such as radi.lton, heat registen, stoves
or other apparatus (including ampllfien) that produce heat
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding-type plug has two blades and
a third grounding prong. The wide blade or the third prong
1s
provided for yoor safety.
If the provided plug does not fit Into your outlet. consult an electrician for replacement
of the obsolete outlet.
10. Protect the power cord flom being walked on or pinched. particularly at plugs, convenience
receptacles and the point where they exit fTom the apparatus.
11. Use only attachments/accessories specified
by
the manufacturer.
12. Use only with the cart, stand, tripod, bracket or table specified by
the manufacturer or sold with the appararus. When a can Is used,
A . - ·
use caution when moving the cart/apparatus combination to avoid •
• ■ .
Injury flom tip-OYel. ,
13. Unplug this apparatus during lightning stonns or when unused for
long periods of time.
14. Refer all servicing to qualified
service
peBOnnel. Servicing
Is
required when the apparatus
has been damaged In any way, such as when the power-supply cord or plug is damaged,
liquid has been spllied or objects hm fallen Into the apparatus, or the apparatus has been
exposed to rain or moisture, does not operate normally or has been dropped.
15. Do not expose this appararus to dripping or splashing, and ensure that no objects filled
with liquids, such as vases, are placed on the apparatus.
16. To disconnect this apparatus
from
the AC mains completely, disconnect the power- supply
cord plug fTom the AC receptacle.
17.
The
mains plug of the power-supply cord shall remain readily operable.
18. Do not expose batteries to excessive heat such
as
sunshine, fire or the like.
19. This appararus is intended to be used only with the
power
supply and/or charging cable
provided by the manufacturer.
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
A
A
THE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL, WITHIN AN
EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE
OF UNINSULATED ' D ANGEROUS VOLTAGE" WITHIN THE PRODUCT' S
ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDETO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED
TO ALERTTHE USER TO THE PRESENCE OF IMPORTANT OPERATING
AND MAINTENANCE (SERVIONG) INSTRUCTIONS IN THE LITERATURE
ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCETHE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR MOISTURE.
CAUTION FCC AND IC STATEMENT FOR USERS (USA AND CANADA ONLY)
This device complies with pan 15 ofthe FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful Interference, and (2) this device must accept
any interference received, including Interference that may cause undesired operation.
CAN ICES-3(B)/NMB-3(B)
FCC SOOC SUPPLIER'S DECLARATION OF CONFORMITY
HARMAN International hereby declares that this equipment Is In compliance with the FCC
Pan 15Subpan8.
The declaration of conformity may be consulted In the support section of our Web site, accessible
flom www.Jbl.com
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Oass 8 digital
device, pu~uant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against hannful interference in a residential Installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used In accordance with
the instructions, may cause hannful Interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause hannful Interference to radio or television reception, which can be detennined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment Into an outlet on a circuit different flom that to which the receiver
Is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by HARMAN could void the user's authority
to operate the equipment.
For Products That Transmit RF Energy:
FCC AND IC INFORMATION FOR USERS
This device complies with Pan 15 of the FCC rules and Industry Canada license-exempt R5S standard(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful
Interference; and (2) this device must accept any Interference received, lnduding Interference that
may cause undesired operation.
FCC/IC Radiation Exposure Statement
This equipment complies with FCUIC RSS-102 radiation exposure limits set forth for an uncontTOlled
environment
For Wi·Fi SG device
FCC Caution:
High power radan are allocated as primary use~ of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands.
These radar stations can cause Interference with and/or damage this device. No configuration controls
are provided for this wireless equipment allowing any change in the flequency of operations outside
the FCC grant of authorization for US operation according to Pan 15.407 of the FCC rules.
IC Caution:
User should also be advised that
(i)
The device for operation in the band 5150 -52S0 MHz Is only for indoor use to reduce the potential
for harmful Interference to co-channel mobile satellite systems; (11) the maxlmum antenna gain
pennitted for devices in the bands 5250 • 5350 MHz and 5470 -5725 MHz shall comply with the
e.i.r.p. limit: and
(ill)
The maximum antenna gain permitted for devices in the band 5725 -5825 MHz shall comply with
the e.i.r.p. limlts sptcified for point-to-point and non point-to-point operation as appropriate.
(iv) Use~ should also be advised that high-power rada~ are allocated as primary users (I.e. prionty
usen) of the bands S2S0 -53S0 MHz and 5650 -58S0 MHz and that these radm could cause
Interference and/or damage to LE-LAN devices.