Table of Contents
Advertisement
GREEN CLASS METER
KWh Meter Hardware Functions
Hardware
AMR Jack
Peripheral Jack
Check Sensor LED
Meter Pulse LED
Power On LED
Reset PB
Display Test PB
DIP Switch
CPU Active LED
AMR Jack
Standard Confi guration
62-0340-01
Function
8-pin RJ-45-used to connect kWh meter to the Honeywell Energy automatic meter reading system.
6-pin RJ-11-used to interface with Honeywell meter options such as the P2 Pulser or D/A Converter.
When lit, indicates that the current sensor is backwards or on the incorrect phase.
Blinks to show the meter load. Blink rate increases with load.
When lit, indicates power to meter is on.
Press (RESET) to reset display to zero.
Press (CPU) to test display. Shows "88888888" then amp rating of meter.
Meter set-up. Used ONLY by Honeywell factory personnel.
One blink per second indicates normal operation.
Peripheral Jack
Fig. 3. Main circuit board located inside meter enclosure.
Power On LED AMR Jack
Check Sensor LED
Meter Pulse LED
Power ON LED
Meter
Terminal Block
14
Peripheral Jack
ST Confi guration
Advertisement
Table of Contents
