CONNECTING DEVICES TO YOUR TV
Your TV's connections are secured behind a panel door on the back of your TV. This
panel is lined with foam to keep dust & moisture out and keep your cords dry and in place.
To access your TV's ports and connect devices, complete the following:
BEFORE MOUNTING:
1. Place TV screen-down on a clean, flat, soft surface (ie: blanket) to prevent scratches
or damage to the screen.
2. Locate the panel door on the back of your TV, remove the seven screws by hand
and open panel door. See figure one.
3. Find the power cord (located inside the door) and run the plug out to the bottom
of the panel. Do not connect to power until all cable connections have been made.
See figure two.
4. Plug in any devices and ensure they are securely connected. Device cords should run flat
out the bottom of the panel (between the two bottom screw holes) and not be layered.
See figure two.
5. Close the panel door and replace the seven screws tightly by hand, ensuring there are
no large gaps between the foam and cords.
8
FIGURE ONE
FIGURE TWO
SAFETY GUIDE
FOR SUPPORT, VISIT ELEMENTELECTRONICS.COM/SUPPORT
power cord
run cords through here
9