Table of Contents
Advertisement
GENERAL __________________________________________________________
•
Adjustments and maintenance should always be performed by a qualified technician. If proper adjustment cannot be
made, contact an authorized Jacobsen Dealer.
•
Replace, do not adjust, worn or damaged components.
•
Long hair, jewelry or loose fitting clothing may get tangled in moving parts.
CAUTION
!
Be careful to prevent entrapment of the hands and
fingers between moving and fixed components of
the machine.
•
Do not change speed limit settings or overspeed the drive motors.
BEDKNIFE-TO-REEL _________________________________________________
(Pre-adjustment Check)
•
Check the reel bearings for end play or radial play. There should be no end play or radial play. See Torque Specifica-
tion on page 86.
CAUTION
!
To prevent personal injury and damage to the cut-
ting edges, wear gloves and handle the reel and
bedknife with extreme care.
•
Inspect the reel blades and bedknife to insure good
sharp edges without bends or nicks.
•
The leading edge of the reel blades must be sharp,
free of burrs and show no signs of rounding off.
•
The bedknife and bedknife backing must be securely
tightened. The bedknife must be straight and sharp.
Lithium
ADJUSTMENTS
Before you clean, adjust, or repair this equipment,
ground, turn system power off, remove key from
ignition switch, and disconnect battery pack(s) to
Make sure the mower is parked on a solid and level
surface. Never work on a mower that is supported
Safety, Operation, & Maintenance Manual
ADJUSTMENTS
WARNING
!
disengage all drives, lower implements to the
prevent injuries
only by the jack. Always use jack stands.
°
B
°
1/32"
(0.08 cm)
en-77
Advertisement
Table of Contents
Troubleshooting
