Viewfinder Indications - JVC GR-FX11EG Instructions Manual

Tape remaining time indicator
25MIN
Recording Start/Stop Button
DISPLAY Button
4
MIN
(Now calculating)
120MIN
NOTES:
119MIN
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
0MIN
(Blinking)

Viewfinder Indications

Press DISPLAY to make the following indications appear/
disappear from the camcorder's display: cassette warning,
tape remaining time, battery pack remaining power
indicator and tape length indicator (
1
NOTE:
Even if the indications are off, the tape remaining time
appears blinking when the tape is near its end, and the
battery pack remaining power indicator appears blinking
when the power is almost gone.
STOP RECORDING
Press the Recording Start/Stop Button again to stop
recording.
•The camcorder re-enters the Record-Standby mode.
The cassette holder cannot be opened unless a power
supply is attached.
There may be a delay after you slide EJECT until the
holder opens. Do not use force.
The tape remaining time is displayed in the viewfinder
as shown.
The remaining time indicated in the viewfinder is
approximate.
The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
The tape remaining time indicator is correct only if the
correct tape length has been selected (
"TAPE END" appears when the tape reaches its end, and
the power goes off automatically if left in this condition
for 5 minutes. "TAPE END" also appears when a cassette
whose tape is already at its end is loaded.
If the Record–Standby mode continues for 5 minutes
without performing zoom or any other operations, the
camcorder's power shuts off automatically. Set the
Power Switch to "OFF", and then back to "CAMERA" to
turn the camcorder on again.
If the Recording Start/Stop button is pressed after the
Record-Standby mode has continued for over
5 minutes, recording may not start immediately.
If you are recording on a cassette from the middle (such
as when a tape is removed and re-inserted during
recording), use the Retake function (
the end of the last recording so you don't erase any of it.
The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on with the cover closed.
To turn the tally lamp off during recording, refer to pgs.
24 and 26.
PRESS DISPLAY BUTTON
To turn off the indications, press DISPLAY for more
than 1 second.
Press again for more than 1 second to make the
indications reappear.
15
EN
pg. 10).
pg. 17) to find
pg. 51).