Cable Connections - Vitek TRANSCENDENT VTC-TNB48R4M2 Quick Start Manual

Cable Connections

First connect the Waterproof Cap to an Ethernet patch cable, then
connect the cameras ethernet adaptor. If not powering the camera with
PoE, also connect the power Cable to an approved 12VDC Power
Supply.
Weather Resistant Network Coupler
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Optional 12VDC
Power Connection.
Not needed with PoE
RS-485 +
RS-485 -
3
ALM: COM
ALM: NO
ALM: IN
ALM: GND