Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG S40340KG18 User Manual

30

Technical data

Problem
The lamp does not work.
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.

Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Height
Width
Depth
Close and open the door.
Refer to "Replacing the lamp".
1
S60300KG
1540 mm
595 mm
658 mm
20 h
230 V
50 Hz
Solution
2
S60340KG1
1750 mm
595 mm
658 mm
20 h
230 V
50 Hz