Shop-Vac SM12 User Manual page 10

FILTER INSTALLATION AND MAINTENANCE (CONT'D.)
3. With the opening of the inlet deflector facing the left or right side of the filter bag,
slide filter bag collar over deflector matching notches of bag collar to tabs on
inlet deflector. Bag will only fit properly one way.
4. Slide deflector with filter bag attached into deflector guide.
5. Reinsert hose into inlet and tighten locking-nut. When secured in place expand bag and position around
inside of tank.
6. NOTE: When removing filter bag from tank, remove inlet deflector from filter bag collar and reinstall into
deflector guide. Inlet deflector should always be in place for any type of cleaning.
WARNING
When vacuuming fine dust, or powders of any kind (plaster, drywall dust, cold ashes, concrete dust, etc.)
a high efficiency drywall filter bag must be used. When vacuuming normal household dust and debris,
standard household disposable filter bags may be used.
WET PICK UP OPERATION
1. Your vacuum can be used for wet pick up. Remove ALL dirt and debris found in the tank. Remove all dry
use filters, including the filter bag, from the vacuum.
2. A clean cartridge filter may be used to pick up small quantities of liquid. To use the cartridge filter;
follow the instructions under dry pick up.
3. For vacuuming large quantities of liquid use a foam sleeve. If a foam sleeve did not come standard with
your unit, one may be purchased at your local dealer, the Shop-Vac
Vac ® customer service. To use the foam sleeve; follow the instructions in this section.
4. Misting in the exhaust air or dripping of liquid around the tank cover may occur if the filter becomes
saturated during wet pick up. If this occurs, remove the filter and allow to dry, or replace with another
dry filter.
5. Turn the unit off immediately upon completing a wet pick up job or when tank is full and ready to be
emptied. When the tank is full, suction will drastically reduce. Refer to the automatic suction shut
off section for more information. Raise the hose to drain any excess liquid into the tank. Follow the
instructions in the emptying liquid waste section.
6. Before storing the vacuum cleaner or using for dry pick up, clean and dry the interior of the tank and the
underside of the tank cover. Clean and allow the filters to dry completely.
7. Wet pick up accessories should be washed periodically; especially after picking up wet, sticky kitchen
accidents. This can be accomplished with a warm solution of soap and water.
FOAM SLEEVE
1. With the tank cover in an upside down position, slide the foam sleeve down over the
lid cage, pulling until foam sleeve completely covers the lid cage.
2. To clean the foam sleeve, slide it up and off the lid cage. Shake excess debris off of the foam sleeve
with a rapid up and down movement.
3. Hold foam sleeve under running water for a couple minutes, rinsing from the inside of the filter. A water
wash is not always required, depending on the condition of the filter.
4. Check the filter for tears. If any are found, replace with a new filter.
PAGE 10
–
FOR FINE DUST AND POWDERS.
®
website or by contacting Shop-