Decode Security - Intermec Trakker Antares 2460 User Manual

3. Scan the number of data bits:
4. Scan this bar code:
5. Repeat Steps 1 through 4 to set the data bits for another serial port.
Notes: For COM1 only, you can use either command syntax listed next:
Syntax:
Or:
where data is a value of 7 or 8 data bits. For COM2, you must use the YI configuration
command.

Decode Security

Purpose: Defines the security level to use when decoding bar codes. When you select a lower
decode security level, the terminal can decode bar codes with poorer print quality.
Note: Only use the low parameter as a temporary solution until you can improve the
bar code label print quality.
Syntax: CSdata
Acceptable values for data are:
0
1
2
Default: Moderate
Scan: One of these bar codes:
Low Decode Security
*$+CS0*
*$+CS0*
C d 39
Nugg
7 Data Bits
*7*
*7*
Exit Accumulate Mode
*-/*
*-/*
YI1.data
IIdata
Low
Moderate
High
Configuration Command Reference
8 Data Bits
*8*
*8*
8
8-33