Cold Start; More - Intermec Trakker Antares 2415 Programmer's Manual

—
Chapter 3 Using the Terminal Emulation Menus
74

6) Cold Start

This resets all TE values to the stored configuration in CONFIG.DAT
and performs a cold-start on the terminal. Press [Y] to reboot the terminal,
or press any other key to return to the 1) Set-up Parms menu.
Depending on the setting in the firmware menu of the terminal, after reboot-
ing, the terminal opens to the TRAKKER Antares 2400 Menu System.
Cold Start Enter
'Y'
to Cold Start
terminal:

7) More

7) More provides the following additional setup parameters:
Set-UP Parms
1) Menu Password
2) Print Device
3) COM Select
1) Menu Password
This parameter enables menu password protection for the TE configura-
tion menus. This provides added protection because once enabled, the
password must be entered before any further activity can occur within the
terminal emulation menu screens. The default is to have this option dis-
abled.
To enable the password, press [1], then type "3193693" for the fixed pass-
word set by Intermec Technologies Corporation. The "1)" will change to
reverse video to indicate it is enabled. With this enabled, enter this password
when you access the terminal emulation menu screens. Press [Enter] until
you reach the Main Menu, then press 6) Exit Menus to return to the
main terminal screen.
To disable the password, press [1] to display in normal viewing text. You
do not need to enter a password to disable this function. Note that the
menu password can be set via a custom configuration. See Chapter 4, "Cus-
tomizing Your Configuration," for help on creating a custom configuration file.
2) Print Device is for 6400
3) COM Select is for 248X, 5055
Native Terminal Emulation Programmer's Guide