Page of 14 Troubleshooting Procedure 1. No power Check 220V power supply voltage and the contact of power socket Check AC(220V)voltage and the contact of CN101 socket. Check +5V and +12V output from Replace power cord or power embedded power supply for abnormity socket Abnormal output voltage +5V and +12V from Check +5V and +12V on...
Page 30
3. Protection or without light (refers to the disappearance of image several seconds after the emergence of image) image disappeared immediately after emergence; check the plug of high-voltage switch board for striking sparks and poor contact No problems identified, replace high-voltage If there is spark striking, board;...
Page 31
5. White screen after power-off (work normally when power on, but when power-off or no signal input, the screen shows a white screen) Check whether there is change of voltage at the high voltage board controlled by main board when power-on and power-off Check whether the voltage change of the control pins on Check whether the voltage of the pin on main chip the plug interface of high voltage board is normal when...
Page 32
7. Poor sound Poor sound refers to without sound or with noise; check whether the selection of sound system is proper Switch to other audio input, check whether DVD No sound; check whether remote control mute is input and PC main board input has sound selected and switch sound system No sound for other inputs;...
Page 33
9. Poor embedded power supply of TV Power on, check embedded power supply 5VSB in TV for 5V voltage output High electrical level existed at Check power supply line for looseness, check indictor for STB (higher than 2.5V) working and power supply socket for looseness Check +5V ,...
Page 34
glass of the pressed portion is not damaged, the liquid crystal body can not display normally, with spot or block black defect. 10.6 Screen mess: irregular color display arising from damage of driving plate in LCD.
Page 35
MSD6308 Program Software Burning Instruction 1. Connect burning board and computer; connect burning board and waiting burning main board VGA socket with VGA connecting wire. burning board To PC USB interface To main board VGA interface , if the hint 2.
Page 36
4. Sorting set the burning board terminal and computer interface make sure the two are all set as automatic connecting. (same as above).
Page 37
Burning board terminal and 烧录板的端口排序必须为 has to be the same as 电脑里的排序一致 sorting set in PC. 6. Click view in toolbar in the main menu, click the second( count backwards) view in main toolbar and the “ Eagle second(count backwards) NAND Program”...
Page 38
Follow these instructions to load the appropriate file Load suffix file .txt Load 050B-Tool.bin file Load RomBoot.bin file Make sure loading right, click here to start burning. When toolbar shows: Success .Please reset power. That means burning finished (Notice: Although the hint shows...
Page 39
complete but it may not be burning completed, wait for 5 minutes to shut off power. If U disk cannot be used for burning, boot file should be burning again until U disk can be used for upgrading. ). After prompting success, then click POWER on button panel to check whether main board can be starting on, if it can be started...
Page 40
LE32M1475/65 MSD6308-T4C1四合一板ISDB(带GINGA)数模一体电视原理图 VER:A1.0 2015-11-26 PAGE Content Index&History Rev Block Diagram Power & LED Driver System Power MSD6308 HDMI page Video&VGA&USB page Amplify &LVDS page Tuner page NAND Flash page History Rev Author DATE Description 11/26/2015 Ver:A1.0 First Version Release ZHQING...