DeWalt D55152 Instruction Manual page 22

CODE POSSIBLE CAUSE
18 Detergent type oil being used in pump
19 Motor overload protection switch has tripped
Extension cord is wrong length or gauge
20
21 Loose electrical connections
Possible defective motor or starting capacitor
22
Paint spray on internal motor parts
23
24 Fuse blown, circuit breaker tripped
25 Tank pressure exceeds pressure switch cut-in pressure
Pressure release valve on pressure switch has not unloaded
26
head pressure
POSSIBLE SOLUTION
Drain oil and refill pump using SAe 5W-40 full synthetic oil.
See Motor Overload under Features.
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
compressor in the paint spray area. See flammable
vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper
extension cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch.
Set the On/Off switch to OFF. If the valve does not open,
replace switch. Contact a D
D WALT authorized service center.
e
22
WALT
e
WALT
e
WALT
e
Do not operate the
WALT factory service center or a
e