Step-By-Step Installation - Intermec 6110 Technical Reference

SECTION 2

Step-by-Step Installation

The following steps are required to install Windows 95 onto your 6110 Computer
using the Windows 95 Toolkit. Additional details are provided later in this sec-
tion.
1. Insert a PC Card into the PC Card drive on your PC (to become a 6110 boot
" NOTE:
If your auto-install feature is not activated, double-click the 6110 Toolkit CD-ROM icon using
My Computer or Windows Explorer, then double-click AUTORUN.EXE on the 6110 Toolkit
CD-ROM drive.
2. Install a preconfigured Windows 95 image to the PC Card, using the Win-
3. Copy your application and all associated files to the PC Card.
4. If you chose a smaller than full load (which means you might need addition-
5. Remove both PC Cards from your PC and insert the 6110 boot card into the
" NOTE:
Use a dock with a keyboard to navigate around the 6110 Computer.
6. Reset the 6110 Computer to boot up to the Windows 95 PC Card and enter
7. Install any additional Windows 95 features such as: dial-up networking,
8. Insert any required PC Card devices such as a radio or a modem, then al-
9. Remove the PC Card containing the application setup files.
" NOTE:
In the process of copying CAB files to a PC Card, the toolkit will remove any Windows 95
image that may exist on the PC Card. If necessary, copy the CAB files manually from the
Toolkit CD onto an existing Windows 95 image.
If you are using the CAB Card installation method, insert the CAB Card in the
6110 Computer before starting the installation. Listen for a beep to ensure that
the 6110 Computer recognizes the CAB Card.
If you are installing two PC Card devices (such as a radio and GPS), you need a
Lite or Full Windows 95 image and the CAB files on one PC Card.
" NOTE:
To put a Windows 95 image and the CAB files (approximately 47 MB) on the same PC Card,
first install the desired Windows 95 image, then manually copy the CAB files to your PC
Card. Use My Computer or Windows Explorer to locate the CAB files in the \Win95\cabs
folder on the Windows 95 CD-ROM drive.
card). Then insert the Windows 95 Toolkit CD into the first CD-ROM drive
on your PC. The toolkit should autorun.
dows 95 Toolkit.
al Windows 95 files), then copy the CAB files to your PC Card (or to another
PC Card) using the toolkit. (Note: CAB files can be removed from the card
after the installation.)
PC Card slot in your 6110 Computer.
the Windows 95 license information. Begin installing your application us-
ing the setup instructions for your application.
using Start → Settings → Control Panel → Add/Remove Programs.
low Windows 95 to auto-detect it and install the appropriate drivers.
6110 Hand-Held Computer Technical Reference
Windows 95 Toolkit
2-3