Am Stop Rate; Am Sweep Time - HP ESG Series User Manual

AM Stop Rate

AM Sweep Time

Use this softkey to change the ending internal modulation frequency for
swept-sine amplitude modulation. To change the value, press the softkey once.
The current value for the AM stop rate is displayed in the active entry area. To
enter a new value, rotate the front panel knob until the desired value is displayed,
use the up and down arrow keys, or enter the value using the numeric keypad and
press the or terminator softkey. The range of values allowed is 0.1 Hz to 50
Hz kHz
kHz. The minimum increment allowed is 0.1 Hz.
This softkey is coupled to the
Any value set for
AM Stop Rate
Conversely, if you change the value for the
is changed to match.
AM Stop Rate
Softkey Location: Press
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTernate <val><unit>
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTernate?
Press this softkey to set the sweep time for swept-sine amplitude modulation. The
signal generator will vary the AM rate from the specified start rate to the stop rate
in the time set with this softkey. Enter the desired sweep time using the up and
down arrow keys, the front panel knob, or enter a value using the numeric keypad
and press the or
sec msec
through 65.535 s. The minimum increment allowed is 1 ms.
Softkey Location: Press
Status after Normal Preset: 100.0 msec
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TIME <val><unit>
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TIME?
softkey in the AM Dual-Sine Menu.
AM Tone 2 Rate
is reflected in the
AM Tone 2 Rate
, ,
AM AM Waveform Swept-Sine
terminator softkey. The range of values allowed is 1 ms
, ,
AM AM Waveform Swept-Sine
Hardkey and Softkey Reference
softkey.
AM Tone 2 Rate
softkey, the value for
,
AM Stop Rate
,
AM Sweep Time
AM
5-9