Connecting External Devices; Ports On The Device; Connecting A Monitor - Fujitsu FUTRO S9011 Operating Manual

Connecting external devices

Read the documentation on the external device before connecting it.
With the exception of USB devices, always remove all power plugs
before connecting external devices!
Do not connect or disconnect cables during a thunderstorm.
Always hold the plug of a cable when removing it. Never unplug a
cable by pulling the cable itself.
To ensure that your device works properly, use only the connection cable
supplied or use a high-quality connection cable.

Ports on the device

Externaldevices Device Ports
The ports are located on the front and rear side of the device. The ports available on
your device depend on the configuration level you have selected. The standard ports are
marked with the symbols shown below (or similar). Detailed information on the location
of the ports is provided in the manual for the mainboard.
Headphone port, black (front
of device)
Headphones
USB 2.0 - Universal Serial
Bus, type A, black
RJ45-LAN port
LANport
Some of the connected devices require special software (e.g. drivers) (refer to the
documentation for the connected device and operating system).

Connecting a monitor

Only attach the screen to your device when it is switched off.
► Follow the instructions contained in the monitor manual to prepare the monitor
for operation (e.g. connecting cables).
Monitor,
► Connect the data cable to the required monitor port on your device.
► Plug the monitor power cable into the grounded mains outlet.
Fujitsu
DP DisplayPort
DisplayPort
USB 3.2 Gen 2 - Universal Serial Bus,
type A: blue, type C: black
UniversalSerialBus
Serial Interface
Serialport
Getting started
19