Advertisement
Figure 1- Rear View Wiring Diagram
If the attached light fixture does not turn ON, slide the Air-Gap Switch (see Figure 2 above) to
the right, into the OFF position (circle "O" shown next to the Air-Gap Switch), and check to
make sure that the lamp bulb is not blown out. Check that all wiring connections are correct
and that all wiring connectors are properly installed.
See the instructions for HA07 Master Remote Control or HA09 Handy Remote Control.
FEDERAL COMMUNICATIONS COMMISSION
This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna or device.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
WARNING!
Changes or modifications not expressly approved by Intermatic Inc. could void the user's authority to operate the equipment.
Intermatic, Inc. Spring Grove, IL 60061 www.intermatic.com
INSTALLATION__________________________
PROGRAMMING
Figure 2 - Front View
STATEMENT_____________
_
158HA11644
Advertisement
