The Reference Series (Rs); Unpacking The Speakers; Installing Feet - Infinity Reference RS-8 Owner's Manual

Figure 1. This cross section shows
how to install a foot onto the bottom of an
RS-8 floorstanding speaker.
T R
HE EFERENCE
All RS Series products use efficient drivers for maximum output with minimal amplifier
power. They are magnetically shielded, making them suitable for home-theater
applications as well.
U
NPACKING THE
If you suspect damage from transit, report it immediately to your dealer and/or delivery
service. Keep the shipping carton and packing materials for future use.
These speakers are covered by a Limited Warranty, so save the sales receipt to protect your
purchase and aid in any service-related questions. Also, save these instructions for future
reference.
I F
NSTALLING EET
Refer to Figure 1 as you perform the following steps:
1. Open each accessory pack and locate the following items: four feet (with spike/round
ends), four locking nuts, four nylon domes and one wrench.
2. Lay each speaker on its side and locate the four threaded holes on the bottom.
3. For carpets, screw the round end of a foot into each hole and hand tighten a nut onto each
one. Leave a minimum of
length of exposed spike up to 1
hole instead and leave " of round end exposed.
5
⁄
8
4. Carefully flip each speaker upright to sit on its feet.
5. If needed, adjust the feet so each speaker is level and then tighten each nut with the
enclosed wrench. To protect hard surfaces (e.g., wood floors), slip a nylon dome onto each
round end.
5 ⁄ "
min.
8
1 1 ⁄ "
max.
8
CARPETED
FLOORS
S (RS)
ERIES
S
PEAKERS
" exposed spike. (On thicker carpets, you can increase the
5 ⁄
8
".) For hard-surface floors, screw the spike end into each
1 ⁄
8
Bottom
Of Speaker
Locking Nut
Foot
round end
spike end
Nylon Dome
(optional for
wood floors)
5 ⁄ "
8
HARD-SURFACE
FLOORS
RS-8 – Owner' s Manual 5